Note - This post discusses techniques and methods used in vertical rope work. If you do them wrong, you could die. Always practice vertical rope techniques under the supervision of a qualified instructor, and ideally in a progression: from flat ground, to staircase, to vertical close to the ground before you ever try them in a real climbing situation.

Here’s a quick and effective way to make an anchor with your rope around an extremely sturdy single point anchor. This is typically a substantial tree or unquestionably strong rock horn.

In this case we’re using a rock horn. If you have a tree, you can walk around it, or if that's not possible, put a long sling / cordelette around it and clip the rope to the sling with a locking carabiner.

If you're using a rock horn, it's probably not good for much of an upward pull. So, if that's the case, and this is your only anchor point, it's best used at the top of a climb when the next step is to walk off or rappel.

Note, in the photo above, there is a very short bit of rope between the knot and the belay device. This was done to keep the photo uncluttered; in real life, you’d have some coils of extra rope here.

Here's how to do it.

1. Find a rock horn that is unquestionably strong and doesn't have any sharp edges around the back. (If using a tree, it's good if it’s not a conifer with sap on it; getting sap on your rope is not fun.)

2. Pull up a couple of meters of slack, and toss a loop of rope over the top of the rock horn.

3. Step down below the rock horn a bit, so there's no chance that the rope can lift over the top. Tie an overhand on a bight knot using both strands of rope. In some circles this is known as a “BHK”, or “Big Honkin’ Knot”.

4. The BHK now secures you (in the photo, that's the strand on the right). It also creates a convenient double loop where you can clip your plaquette belay device, insert the rope, and bring up your second. If you need to shorten up the distance between you and the BHK, tie a bight knot to take up some slack.

5. Done!

Now, in fairness, let's look at some downsides of using your rope to make an anchor like this.

• It could get damaged from being loaded around a sharp edge of the boulder / rock horn.

• If you put it around a conifer tree, you could get tree sap on your rope, no fun.

• It makes escaping the belay if you need to do some kind of self rescue a bit more of a problem.

• On a multi pitch route, if you’re seconding, when you break down your rope anchor it introduces more slack that your partner above you now needs to take up.