Climbing Tips: Do This, Not That (Part 2)
Premium Members can read the entire article here:
1 - Quad anchor - keep the knots low
With a quad anchor, if you’re using a cordelette or longer sewn sling like a 180 cm or 240 cm, it's good practice to tie the knots low down as shown. This will give perfect equalization, but minimizes extension if one arm of the anchor fails.
2 -The (mostly) twist-free Munter hitch rappel
Rappelling on a Munter hitch usually makes evil pigtails/twists in your rope. This can be a serious problem when you pull your rope, because the twists can get caught at the anchor.
However, if you flip your rope back over the carabiner like the photo below, this greatly reduces the rope twists.
3-Don't put rubber bands or tape on an “open" sling
Almost all quickdraws have some sort of a little rubber band thing on the bottom carabiner. This makes it easier to clip.
Some people think that doing the same thing on a “open” sling or alpine quickdraw might also be a good idea. Don’t do this!
If you clip that bottom carabiner back onto the sling, it can configure itself so the entire load is resting only on the rubber band and not on the sling! Yes, there have been two accidents that I know about caused by this.
It's a little hard to describe, but if you play around with it, you can figure it out.
The same applies to a personal tether. Do not put tape or a rubber band on a sling that you use for your tether. If you want to make it a bit easier to clip, use a girth hitch, or maybe better a clove hitch, to hold the carabiner in place.
How can you set up your haul system faster, and never drop the rope or your progress capture pulley?
Why can it be helpful to cut tubular webbing at a 45° angle instead of a 90° angle?
