Climbing Tips: Do This, Not That (Part 1)
Premium Members can read the entire article here:
1 - Anchor hooks: gates facing out
In a typical anchor with carabiners, it's usually good practice to place them opposite and opposed. However, with anchor hooks (aka Mussy hooks), it's typically best to have them both facing OUT, away from the rock.
Why is this?
The American Safe Climbing Association has installed thousands of these anchors throughout the US. They recommend gates out. Click the article link above to read the longer reasons; here’s the short version:
“Anchor hooks are placed with gates out for a couple reasons. If opposed the inward facing hook tends to gouge into the rock and scar it up, along with orienting strangely to wear much faster on the nose or even get pushed into the bottom of the wiregate. If they are extended with chains to lay flat and opposed the rope gets pinched behind the hooks and wears unnecessarily/grooves the rock.“
2 - How to extend a quickdraw
A steep or reachy sport route may require extended quickdraws.
It's good practice to extend them as shown in the photo below. Of these two, the quick link is more secure. Or you could have a locking carabiner in the middle (left photo) to add further security.
The methods shown below are not so great. In the left, the carabiners could be twisted and unclipped in a fall. On the right, the rope can rub over the top of the dog bone, not good.
3 - Protect a fixed rope with a rebelay
If a fixed rope is running over an edge, it's quite easy to damage the rope, especially with a larger load.
An easy way to fix this: a rebelay. To make a rebelay, make another anchor point (by placing gear or clipping a bolt) below the edge that's being loaded. Pull up a bit of slack, tie a bight knot, and clip that bight to the lower anchor. Now, when the rope is loaded, no force goes to the section of rope over the edge.
For “alpine equalization”, where should you clip the cam?
What anchor rigging can cause rope twisting, and hoe can you fix it?
